Liquid Parking Heater For Truck

After the liquid parking heater TT-C5 is connected to the heating system of the car, it can be used for: 

- Car compartment heating and heating;

 - Defrost the front windshield, and 

- Pre-heat the engine with cold water. 

The liquid parking heater is not affected by the vehicle engine when it works, and is connected to the vehicle's cooling system, fuel system and electrical system

Structure type	Liquid parking heater with evaporative burner
Fuel	Diesel
Fuel consumption	Full load 0.61 l/h  Partial load 0.30 l/h
Rated voltage	12V
Operating Voltage	10.5V-15V
Capacity of heat exchanger	0.15L
The minimum amount of cooling water in the water route	4L
Minimum water flow of heater	250 l/h
Allowed operating pressure (Cooling water)	0.4 ... 2.5 bar
Capacity of heat exchanger	0.15L

Installation

Liquid parking heaters are only allowed to be installed outside the car. The heater is best installed in the engine room, the splash protection area of the front fender, or the fender. The heater should be installed as low as possible to ensure that the heater and the water pump can automatically exhaust. This is especially true for pumps that cannot pump independently. Note: In any possible installation position, the nozzle of the water pipe should not face downwards. 

Note: The heater must not be installed in: 

-Places close to or higher than high temperature parts in the car;

 -The direct splash area of the wheel; 

-Below the car's wading line.

Error code

If you're looking for the liquid parking heater for truck, welcome to wholesale the product from our factory. As one of the leading manufacturers and suppliers in China, we will offer you the best service and fast delivery. Now, check the quotation with our seller.

Hot Tags: liquid parking heater for truck, China, factory, suppliers, manufacturers, seller, wholesale, quotation