Latest Products

  • 20kw Electric PTC Heater
  • 6KW E-Gas Hot Water And Warm Air Integrated Heater
  • 2.5kw High Voltage Coolant Heater
  • 7kw High Voltage Coolant Heater
  • 5KW High Voltage Coolant PTC Heater
  • 10kw PTC Coolant Heater

Contact Us

    Hebei Nanfeng Automobile Equipment (Group) Co.,Ltd

    Phone: +86 18811334770

    Tel: +86 0317 8620396

    Tel: +86 010 58673556

    Candy Jiao

    E-mail: nh.jiao@auto-parkingheater.com

    Email: nh.li@auto-parkingheater.com

    Add: Room 505, Building B, Free Town Center, No.58, East Third Ring South Road, Chaoyang District, Beijing, 100022, P.R.China

Water Heater For RV video

Water Heater For RV

Water and air integrated heater for RV is a special heater for caravan that integrates hot water and warm air. This heater cannot be used in bus or dangerous goods carriers. Hebei Nanfeng Group is the largest manufacturer of heating and cooling equipment in China and the designated supplier of Chinese military vehicles.

Description

Water Heater for RV

 

Products Description

combi heater 2

 

 

Control Panel:

controller of combi heater

 

 

 

Products Parameters

 

Rated Voltage DC12V
Operating Voltage Range DC10.5V~16V 
Short-term Maximum Power Consumption 8-10A
Average Power Consumption 1.8-4A 
Fuel type diesel/petrol
 Gas Heat Power (W) 2000 4000 
Fuel Consumption (g/h) 240/270
Gas Pressure  30mbar
Warm Air Delivery Volume m3/h 287max 
Water Tank Capacity 10L 
Maximum Pressure of Water Pump 2.8bar
Maximum Pressure of System 4.5bar
Rated Electric Supply Voltage ~220V/110V
Electrical Heating Power  900W 1800W
Electrical Power Dissipation  3.9A/7.8A 7.8A/15.6A
Working (Environment) Temperature -25℃~+80℃
Weight (kg) 15.6kg 
Dimensions (mm) 510×450×300
Working Altitude  ≤1500m 

 

 

Installation and Application

 

 

 

 

water and air combi heater inatallation.jpg
combi heater.jpg
integrated heater application.jpg
application of combi heater8.jpg

 

Warm Air Intake
The warm air intake is drawn in by the heater. There must be a total area between the room and the heater not less than 150cm2 opening. Ensure that the warm air intake is not contaminated by the engine or heater exhaust, if necessary, with structural isolation measures.


Installation of oil pipe
Only the flexible nylon pipe, which has good light-resistance and thermal stability, supplied with the heater can be used as the fuel pipe. Allowable length of fuel line: the maximum length of fuel line on the inlet side is 2 meters, and the maximum length on the pressure side is 6 meters.

 

Installation of oil pump
The oil pump shall be fixed with a fixed jacket (rubber) of the oil pump. The outlet of the oil pump should be inclined upward, and its installation angle should be selected in the range of 15- 35 as shown in Figure 14. When conditions permit, the tubing between the pump and the
heater mainframe should gradually rise. In order to prevent the oil pump from being heated (the maximum operating temperature is 40 C), do not install it near the exhaust pipe. The height difference between the fuel level and the oil pump, and the height difference between the oil pump and the main engine inlet, will generate pressure (or suction) in the oil pipeline, so these dimensions should meet the requirements of Figure 14 (negative pressure will occur in the closed tank, when the minimum liquid level of the tank is required to be no more than 0.4m).

 

Packing 

 

integrated heater packing

 

 

If you're looking for the water heater for rv, welcome to wholesale the product from our factory. As one of the leading manufacturers and suppliers in China, we will offer you the best service and fast delivery. Now, check the quotation with our seller.

Hot Tags: water heater for rv, China, factory, suppliers, manufacturers, seller, wholesale, quotation

Send Inquiry

(0/10)

clearall